Tripp Lite OMNI750ISO 750VA Line-Interactive UPS Tower Battery Backup


DiscTech Item #: TRI-OMNI750ISO-BN-2Y

  • Low Stock:Call for ETA
    Stock Levels

    This item is currently (nearly) out of stock. It may be possible to arrange fast shipment. If you need it urgently call us. Otherwise, it usually ships within 1 week.


Interface Types: IEC 5-15P

Bays/Ports/Slots: 6

U Height: 2U

Wattage/VA: 500W

Voltage: 110-120V

Tripp Lite OmniSmart OMNI750ISO 120V 750VA 500W Line-Interactive UPS Tower Battery Backup w/ Built-In Isolation Transformer & USB port - Brand New

Tripp Lite OmniSmart OMNI750ISO 120V / 120 Volt 750VA / 750 Volt-Amps 500W / 500 Watts Line-Interactive UPS / Uninterruptible Power Supply Tower Battery Backup with 6 UPS-supported AC outlets and w/ Built-In Isolation Transformer with Faraday shield & USB communications port - Brand New

OmniSmart 120V 750VA 500W Line-Interactive UPS, Tower, Built-In Isolation Transformer, USB port

Tripp Lite's OMNI750ISO offers complete UPS protection with built-in line-interactive voltage regulation, intelligent monitoring and unattended shutdown capability. Built-in isolation transformer with Faraday shield offers full isolation and complete common mode noise rejection. 750VA power-handling capacity supports point-of-sale applications, computers, internetworking equipment and home theater systems during commercial power failures. Line-interactive voltage regulation corrects brownouts as low as 81V and overvoltages as high as 143V back to normal 120V levels, saving battery power for use during complete power failures. Built-in USB communications port works with PowerAlert Software and cabling to provide automatic unattended shutdown of connected network and PC applications.


  • 750VA line-interactive UPS with Faraday-shielded, low-impedance isolation transformer delivers full isolation from potential damage and performance problems
  • Provides immunity from EMI/RFI line noise in both normal and common modes. Delivers clean signal reference ground, reducing data errors and audio/video distortion
  • Automatic voltage regulation (AVR) automatically corrects incoming voltage to keep equipment working through low voltage (brownouts) as low as 81V and overvoltages as high as 143V without consuming battery power
  • Supports loads up to 750VA/500W
  • Offers 31.3 min. battery runtime with a half load of 375VA/250W and 13.5 min. with a full load of 750VA/500 watts
  • Electrostatic discharge (ESD) resistance reduces potential static damage to connected electronics
  • USB port enables data-saving unattended shutdown when used with Tripp Lite's PowerAlert software, available via FREE download from
  • Built-in surge suppression (backed by $200,000 Ultimate Lifetime Insurance U.S., Canada, and Puerto Rico only) safeguards connected equipment against damage
  • SURGE VOLTAGE WITHSTAND CAPABILITY: ANSI/IEEE C62.41 Catagories A & B 6KV/200/500 amp 100Khz Ringwave and category B BiWave
  • SURGE VOLTAGE ATTENUATION: N-G 2000:1, L-G 240:1, L-N 100:1
  • INSERTION LOSS: 65 db N-G from 10Khz to 100Khz, 45 to 60 db L-G from 10Khz to 100Khz, 18 to 54 db L-N from 50Khz to 500 Khz
  • 6 UPS-supported AC outlets; 6-ft. cord
  • 5 diagnostic LEDs indicate AC present, on battery, voltage correction status, overload and battery low/replace
  • Optional PDUB15 bypass PDU enables hot-swappable UPS replacement with no disruption to connected equipment


  • 750VA tower 120V line interactive UPS with isolation transformer
  • Corrects brownouts and overvoltages from 81V to 143V
  • USB port, Normal & common mode EMI/RFI line noise immunity
  • NEMA 5-15P input plug and 6 5-15R outlets

Package Includes

  • OMNI750ISO UPS system
  • USB cable
  • Instruction manual

Model NumberOMNI750ISO
UPS TypeLine-Interactive
Output Volt Amp Capacity (VA)750
Output Watt Capacity (Watts)500
Nominal Voltage Details115v nominal output in battery mode
Frequency Compatibility60 Hz
Output Voltage Regulation (Line Mode)
  • -18%
  • +8%
  • Output Voltage Regulation (Battery Mode)+/-5%
    Hot-Swap PDU optionsPDUB15 (2U / 8 5-15R outlets)
    Output AC Waveform (AC Mode)Sine wave
    Output AC Waveform (Battery Mode)PMW Sine wave
    Nominal Output Voltage(s) Supported
  • 110V
  • 115V
  • 120V
  • Output Receptacles(6) 5-15R
    Individually Controllable Load Banks

    Select UPS models have their receptacles divided into one or more load banks (labeled LOAD 1, etc) which may be remotely switched OFF and ON using Tripp Lite UPS software without interrupting power to equipment connected to the other outlets
    Rated input current (Maximum Load)5.5A
    Nominal Input Voltage(s) Supported120V AC
    UPS Input Connection Type5-15P
    UPS Input Cord Length (ft.)6
    Recommended Electrical Service15A 120V
    Input PhaseSingle-Phase
    Full Load Runtime (min.)

    The amount of runtime th UPS will offer when you
    13.5 min. (500w)
    Half Load Runtime (min.)

    The amount of runtime th UPS will offer when you
    31.3 min. (250w)
    DC System Voltage (VDC)36
    Battery Recharge Rate (Included Batteries)Less than 4.5 hours from 10% to 90%
    Internal UPS Replacement Battery CartridgeRBC53
    Battery AccessBattery access door
    Battery Replacement DescriptionHot-swappable, user replaceable batteries
    Expandable RuntimeNo
    Voltage Regulation DescriptionAutomatic voltage regulation (AVR) maintains line power operation with an input voltage range of 81 to 143
    Overvoltage Correction

    A feature found in line conditioners and select UPS systems that maintains mains-level power to equipment when prolonged line voltages are lower than normal
    Input voltages between 128 and 143V are reduced by 9%
    Undervoltage Correction

    A feature found in line conditioners and select UPS systems that maintains mains-level power to equipment when prolonged line voltages are lower than normal
    Input voltages between 97 and 107V are boosted by 10%
    Severe Undervoltage CorrectionInput voltages between 81 and 96V are boosted by 21%
    Switches2 Switches control off/on power status and alarm-cancel/self-test operation
    Alarm Cancel Operation
  • Power-fail alarm can be silenced using alarm-cancel switch
  • once silenced, alarm will re-sound to indicate low-battery status
  • Audible AlarmAlarm reports low-battery, fault, overload and replace battery conditions
    LED Indicators5 LEDs indicate line power, battery power, overload, voltage regulation and battery low/replace status
    UPS AC Suppression Joule Rating510
    UPS AC Suppression Response TimeInstantaneous
    EMI / RFI AC Noise Suppression

    Technology found in select UPS systems that protects against EMI (electromagnetic inerference) and RFI (radio frequency interface) line noise and protects equipment against associated incremental hardware damage, data corruption and audio/video transmission problems
    Output Isolation Transformer

    A feature found in isolation transformers and select UPS systems where the output power is fully isolated from EMI/RFI line noise, protecting sensitive equipment form potential damage and perfromace problems
    Professional grade load isolation transformer
    Surge Voltage Withstand CapabilityANSI/IEEE C62.41 Categories A & B 6KV/200/500 amp 100Khz Ringwave and category B BiWave
    Surge Voltage Attenuation
  • N-G 2000:1
  • L-G 240:1
  • L-N 100:1
  • Insertion Loss

    The loss of signal power resulting from the insertion of a device in a transmission line or optical fiber. Is usually expresed in decibels (dB)
  • 65 db N-G from 10Khz to 100Khz
  • 45 to 60 db L-G from 10Khz to 100Khz
  • 18 to 54 db L-N from 50Khz to 500 Khz
    Cooling MethodFan
    Installation Form Factors Supported with Included AccessoriesTower
    Installation Form Factors Supported with Optional AccessoriesWallmount (UPSWM - tower mounting kit)
    Primary Form FactorTower
    Primary UPS Depth (mm)234
    Primary UPS Height (mm)325
    Primary UPS Width (mm)191
    Shipping Dimensions (hwd / in.)18.25 x 12.00 x 13.75
    Shipping Weight (lbs.)40.00
    UPS Housing MaterialPVC
    UPS Power Module Dimensions (hwd, in.)12.8 x 7.5 x 9.2
    UPS Power Module Weight (kg)16.51
    UPS Power Module Weight (lbs.)36.4
    Operating Temperature Range+32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius.
    Storage Temperature Range+5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius.
    Relative HumidityUp to 95%, non-condensing
    AC Mode Efficiency Rating (100% Load)>91%
    Communications InterfaceUSB
    PowerAlert SoftwareFor local monitoring via the UPS’s built-in USB communications port, download PowerAlert Local software at
    Communications CableUSB interface cable included
    WatchDog CompatibilitySupports Watchdog application, OS and hard-reboot restart options for remote applications
    Transfer Time

    The time it takes for a UPS to switch from AC on-line mode to DC battery-powered mode. Measured in milliseconds (ms)
    2-4 milliseconds
    Low Voltage Transfer to Battery Power (Setpoint)81
    High Voltage Transfer to Battery Power (Setpoint)143
    Cold Start (Startup in Battery Mode During a Power Failure)Cold-start operation supported
    High Availability UPS FeaturesHot swappable batteries
    UPS Certifications
  • Tested to UL1778 (USA)
  • Tested to CSA (Canada)
  • Meets FCC Part 15 Category B (EMI)
    Product Warranty Period (U.S. & Canada)2-year limited warranty
    Connected Equipment Insurance (U.S., Canada & Puerto Rico)$200,000 Ultimate Lifetime Insurance

    Click here to view the manufacturer's item description/brochure

    Weight: 37 lb

    Warranty: 2 Year Manufacturer

    Brand New

    Condition Levels Explained

    The product is brand new.

    2 Year Manufacturer Warranty

    Product Warranties Explained

    The product has a manufacturer warranty for the time period specified.